yumyumsalad Posted November 1 I'd like to attempt some modification by shaving this head's chin a bit for a rounder look, but would that be achievable? Will I have to use a dremel tool? Share this post Link to post Share on other sites
finnleo Posted November 1 Any abrasives will do, for sandpaper you just need to have suitable grits at your disposal, rougher (lower number) to get the bulk of the work done, and then finer (higher number) to fine tune the surface. I think a suitable starting point would be 320 grit, and moving up from there. at least I recall doing that when adjusting a 02-head to look more like shinon for funzies. The biggest worry is having enough material to work with. I also remember people adjusting noses have run into air bubbles in the vinyl while working, so experiment on something you can easily replace. 1 Share this post Link to post Share on other sites
yumyumsalad Posted November 1 9 hours ago, finnleo said: Any abrasives will do, for sandpaper you just need to have suitable grits at your disposal, rougher (lower number) to get the bulk of the work done, and then finer (higher number) to fine tune the surface. I think a suitable starting point would be 320 grit, and moving up from there. at least I recall doing that when adjusting a 02-head to look more like shinon for funzies. The biggest worry is having enough material to work with. I also remember people adjusting noses have run into air bubbles in the vinyl while working, so experiment on something you can easily replace. Thank you for your answer!! Share this post Link to post Share on other sites